Getting The Best Swim Spa Cover

Swim Spas represent distinct challenges when it comes to covering them.
We can all concur that the swim spa needs to be covered when not in use for all the same factors a hot tub needs a cover. The obstacle is that because of the length of the swim spa and the height of the sides, eliminating and replacing the cover can be a lot harder.
Getting a new swim spa is an amazing occasion in life. You’re eagerly anticipating the exercise you’ll obtain from using it. Perhaps you’re a little relieved to have lastly made a selection from the different designs you looked at. At any rate, you most likely weren’t thinking much about the cover you would use.
Usually, the cover that gets home with your brand-new purchase will be a 4 area rigid foam filled cover that will divide in the center and go off both ends.
No big deal.
Until it begins to get heavy.
Which it constantly does.
Every rigid foam filled Swim Spa Cover ever made ends up the same way and it is not the fault of the user. It’s a design flaw. Built in obsolescence due to the fact that as quickly as it is put in use over the warm water in your swim spa it is unavoidable.
It’s not from rain, so having a taper will not make any difference. In fact you could have it under a roof and the cover will still get heavy.
The factor is the steam from the water. The molecules of steam are really little as they increase from the water surface. They make their way into the little fractures and crevices in the foam.

Then as the steam cools it forms back into a liquid and becomes caught in the cover.
It occurs slowly and on a Swim Spa Cover which is made of individual areas, at differing speeds. So eventually you’ll observe one or two of the areas are really getting heavy. The bar lifters on the ends of the swim spa aren’t much assistance since you still have to raise that heavy cover back up onto the spa which is a lot higher than a routine spa.
This is why SpaCap.com came up with a different design for their Swim Spa Covers
Instead of using a number of foam panels to develop Swim Spa Covers that will eventually wind up in some garbage dump, they designed one that utilizes air chambers that do not suck up wetness.
In fact SpaCap.com Swim Spa Covers are lightweight, insulate much better, will not blow away in a wind storm or be damaged by snow or hail.
Covered with Sunbrella Marine material, these covers will not fade, or break down at the joints either. So if you own a swim spa, and you plan to keep using it everyday, SpaCap.com has the cover for it.
If you’re not prepared to purchase today, bookmark this website so you can find it once again when you’re prepared!

Leave a Reply

Your email address will not be published. Required fields are marked *