Getting The Best Swim Spa Cover

Swim Spas represent unique challenges when it pertains to covering them.
We can all agree that the swim spa has to be covered when not in use for all the same factors a hot tub needs a cover. The difficulty is that because of the length of the swim spa and the height of the sides, removing and replacing the cover can be a lot harder.
Getting a brand-new swim spa is an interesting occasion in life. You’re anticipating the exercise you’ll receive from using it. Maybe you’re a little relieved to have finally made a selection from the various designs you looked at. At any rate, you most likely weren’t believing much about the cover you would use.
Usually, the cover that gets home with your brand-new purchase will be a 4 section rigid foam filled cover that will divide in the center and go off both ends.
No big deal.
Until it begins to get heavy.
Which it constantly does.
Every rigid foam filled Swim Spa Cover ever made winds up the same way and it is not the fault of the user. It’s a style flaw. Integrated in obsolescence due to the fact that as soon as it is positioned in use over the warm water in your swim spa it is inescapable.
It’s not from rain, so having a taper will not make any distinction. In fact you could have it under a roof and the cover will still get heavy.
The reason is the steam from the water. The molecules of steam are extremely small as they increase from the water surface. They make their way into the little fractures and crevices in the foam. Then as the steam cools it forms back into a liquid and ends up being caught in the cover.
It occurs slowly and on a Swim Spa Cover which is made from specific areas, at varying speeds. So eventually you’ll see one or two of the sections are actually getting heavy. The bar lifters on the ends of the swim spa aren’t much help since you still need to raise that heavy cover back up onto the spa which is a lot higher than a routine spa.
This is why SpaCap.com came up with a different style for their Swim Spa Covers
Instead of using numerous foam panels to develop Swim Spa Covers that will eventually wind up in some garbage dump, they developed one that uses air chambers that do not suck up wetness.
In fact SpaCap.com Swim Spa Covers are lightweight, insulate better, won’t blow away in a wind storm or be damaged by snow or hail.
Covered with Sunbrella Marine fabric, these covers won’t fade, or fall apart at the joints either. So if you own a swim spa, and you mean to keep using it daily, SpaCap.com has the cover for it.
If you’re not ready to buy today, bookmark this website so you can find it again when you’re all set!

Leave a Reply

Your email address will not be published.