The Challenges to Swim Spa Covers

Swim Spas represent distinct obstacles when it pertains to covering them.
We can all agree that the swim spa needs to be covered when not in use for all the same factors a hot tub requires a cover. The challenge is that because of the length of the swim spa and the height of the sides, eliminating and replacing the cover can be a lot more difficult.
Getting a brand-new swim spa is an interesting occasion in life. You’re looking forward to the workout you’ll receive from using it. Perhaps you’re a little relieved to have actually finally made a selection from the various models you looked at. At any rate, you probably weren’t thinking much about the cover you would use.
Generally, the cover that gets back with your new purchase will be a four area stiff foam filled cover that will split in the center and go off both ends.
No big deal.
Until it starts to get heavy.
Which it always does.
Every stiff foam filled Swim Spa Cover ever made ends up the same way and it is not the fault of the user. It’s a design flaw. Built in obsolescence since as quickly as it is placed in use over the warm water in your swim spa it is unavoidable.
It’s not from rain, so having a taper won’t make any difference. In fact you could have it under a roof and the cover will still get heavy.
The reason is the steam from the water. The molecules of steam are really small as they rise from the water surface area. They make their method into the little fractures and crevices in the foam. Then as the steam cools it forms back into a liquid and becomes trapped in the cover.

It occurs slowly and on a Swim Spa Cover which is made of specific areas, at varying speeds. So eventually you’ll see a couple of of the areas are really getting heavy. The bar lifters on completions of the swim spa aren’t much aid due to the fact that you still have to raise that heavy cover back up onto the spa which is a lot higher than a routine spa.
This is why SpaCap.com developed a different design for their Swim Spa Covers
Instead of using several foam panels to develop Swim Spa Covers that will eventually end up in some land fill, they created one that utilizes air chambers that do not suck up moisture.
In fact SpaCap.com Swim Spa Covers are light-weight, insulate much better, will not blow away in a wind storm or be harmed by snow or hail.
Covered with Sunbrella Marine fabric, these covers won’t fade, or fall apart at the joints either. So if you own a swim spa, and you mean to keep using it daily, SpaCap.com has the Swim Spa Cover for it.
If you’re not all set to order today, bookmark this website so you can find it once again when you’re prepared!