The Challenges to Swim Spa Covers

Swim Spas represent special obstacles when it pertains to covering them.
We can all concur that the swim spa needs to be covered when not in use for all the same reasons a hot tub requires a cover. The challenge is that because of the length of the swim spa and the height of the sides, eliminating and replacing the cover can be a lot harder.
Getting a brand-new swim spa is an exciting occasion in life. You’re eagerly anticipating the exercise you’ll get from using it. Perhaps you’re a little relieved to have finally selected from the various models you took a look at. At any rate, you probably weren’t believing much about the cover you would use.
Normally, the cover that comes home with your brand-new purchase will be a 4 area stiff foam filled cover that will divide in the center and go off both ends.
No big deal.
Till it begins to get heavy.
Which it constantly does.
Every rigid foam filled Swim Spa Cover ever made winds up the same way and it is not the fault of the user. It’s a style defect. Integrated in obsolescence because as quickly as it is positioned in use over the warm water in your swim spa it is inevitable.
It’s not from rain, so having a taper will not make any distinction. In fact you could have it under a roof and the cover will still get heavy.
The reason is the steam from the water. The molecules of steam are extremely little as they increase from the water surface. They make their way into the little cracks and crevices in the foam. Then as the steam cools it forms back into a liquid and becomes caught in the cover.
It happens slowly and on a Swim Spa Cover which is made from individual areas, at varying speeds. So eventually you’ll observe one or two of the areas are truly getting heavy. The bar lifters on completions of the swim spa aren’t much help since you still need to raise that heavy cover back up onto the spa which is a lot higher than a regular spa.
This is why SpaCap.com created a various design for their Swim Spa Covers
Instead of using numerous foam panels to build Swim Spa Covers that will eventually wind up in some garbage dump, they created one that uses air chambers that do not suck up moisture.
In fact SpaCap.com Swim Spa Covers are lightweight, insulate better, won’t blow away in a wind storm or be damaged by snow or hail.
Covered with Sunbrella Marine fabric, these covers won’t fade, or break down at the joints either. So if you own a swim spa, and you mean to keep using it everyday, SpaCap.com has the Swim Spa Cover for it.
If you’re not all set to purchase today, bookmark this site so you can discover it once again when you’re ready!

Leave a Reply

Your email address will not be published. Required fields are marked *